For inquiries about our products or price list , please leave your email to us and we will be in touch within 24 hour
35kV Aerial Overhead Power Line Cable (tree wire and spacer cable) ACSR (compact) 3-layer track-resistant PE is used on a tree wire or spacer cable, manufactured, tested and marked in accordance with ICEA S-121-733, the standard for Tree Wire and Messenger Supported Spacer Cable.
This 3-layer system consists of a conductor shield (layer #1), followed by a 2-layer covering (layers #2 and #3).
Aerial Overhead Power Line Cable (tree wire and spacer cable) is intended for use in overhead primary and secondary distribution systems rated 35 kV (nominal) typically to prevent faults due to contact or where space is limited.
The track resistant 3-layer system prevents short-circuits and flashovers in the case of contact with trees or wildlife. When installed correctly, this system is effective at preventing system outages, damage, or fires as a result of falling trees or branches.
When used in a tree wire power system, it is installed in a flat configuration, in a similar manner and spacing on insulators as with bare or covered overhead conductors. Self-supporting conductors, such as ACSR, are typical in this type of installation.
When used in a spacer cable power system, it is installed with a uniform spacing in a diamond configuration maintained by spacer hardware. The spacer and cable assembly are supported by a bare messenger, such as bare aluminum clad steel, ACSR, OPGW, or galvanized steel wire.
Spacer cable assemblies occupy minimal space, requiring the narrowest of right of way or corridor.
Single cable with an ACSR conductor, a 3-layer extruded shield and covering system, consisting of an extruded semiconducting thermoset conductor shield, and a 2-layer covering.
The covering inner layer is a crosslinked polyethylene (XLPE), while the outer layer is track-resistant crosslinked polyethylene (TK-XLPE).
All layers are bonded together.
Conductor:
AAC (1350-H19, compact stranded).
Conductor Shield:
Extruded semiconducting thermoplastic shield which is free stripping from the conductor and bonded to the covering.
Inner and Outer Covering:
2-layer crosslinked polyethylene covering (XLPE), where the outer layer is track-resistant (TK-XLPE). All layers are bonded together. The outer layer shall be black or gray, sunlight resistant and track resistant.
These cables are manufactured and tested to meet or exceed the following standards:
- ASTM B230 – Aluminum 1350–H19 Wire for Electrical Purposes
- ASTM B231 – Concentric-Lay-Stranded Aluminum 1350 Conductors
- ASTM B400 – Compact Round Concentric-Lay-Stranded Conductors
- ASTM D1248 – Polyethylene Plastics Extrusion Materials for Wire and Cable
- ICEA S-121-733 – Tree Wire and Messenger Supported Spacer Cable
For inquiries about our products or price list , please leave your email to us and we will be in touch within 24 hour